This patch also enables non-blocking streams on stmhal port.
One can now make a USB-UART pass-through function:
def pass_through(usb, uart):
while True:
select.select([usb, uart], [], [])
if usb.any():
uart.write(usb.read(256))
if uart.any():
usb.write(uart.read(256))
pass_through(pyb.USB_VCP(), pyb.UART(1, 9600))
This allows to implement KeyboardInterrupt on unix, and a much safer
ctrl-C in stmhal port. First ctrl-C is a soft one, with hope that VM
will notice it; second ctrl-C is a hard one that kills anything (for
both unix and stmhal).
One needs to check for a pending exception in the VM only for jump
opcodes. Others can't produce an infinite loop (infinite recursion is
caught by stack check).
Make a clearer distinction between init functions that must be done
before any scripts can run (xxx_init0) and those that can be safely
deferred (xxx_init).
Fix bug initialising USB VCP exception. Addresses issue #788.
Re-order some init function to improve reliability of
reset/soft-reset.
Before, pyb.stdin/pyb.stdout allowed some kind of access to the USB VCP
device, but it was basic access.
This patch adds a proper USB_VCP class and object with much more control
over the USB VCP device. Create an object with pyb.USB_VCP(), then use
this object as if it were a UART object. It has send, recv, read,
write, and other methods. send and recv allow a timeout to be specified.
Addresses issue 774.
Recent changes to builtin print meant that print was printing to the
mp_sys_stdout_obj, which was sending data raw to the USB CDC device.
The data should be cooked so that \n turns into \r\n.
Blanket wide to all .c and .h files. Some files originating from ST are
difficult to deal with (license wise) so it was left out of those.
Also merged modpyb.h, modos.h, modstm.h and modtime.h in stmhal/.
All board config macros now begin with MICROPY_HW_.
Renamed PYBv10 to PYBV10, since macros should be all uppercase.
Made SDCARD_DETECT configurable in mpconfigport.h, so that the SD
detect pin can be easily configured.
Can now choose at boot up whether the USB device is CDC+MSC or CDC+HID.
Choice is made by an option in boot.py, with default being CDC+MSC.
HID+MSC is not currently supported, but should be easy to implement.
Boot up now has ability to change the reset mode: hold down USR switch
while booting and LEDs will count from 1 to 7 to indicate the boot mode.
Release USR when correct mode is selected. Current modes are 1 (normal
boot), 2 (safe mode), 3 (reset FS mode).
New USB HAL is quite a bit improved over previous one. Now has better
callbacks and flow control.
REPL over USB CDC now works as before, except for soft-reset (since USB
driver uses malloc...).
Each built-in exception is now a type, with base type BaseException.
C exceptions are created by passing a pointer to the exception type to
make an instance of. When raising an exception from the VM, an
instance is created automatically if an exception type is raised (as
opposed to an exception instance).
Exception matching (RT_BINARY_OP_EXCEPTION_MATCH) is now proper.
Handling of parse error changed to match new exceptions.
mp_const_type renamed to mp_type_type for consistency.
Using PendSV interrupt at lowest priority, code can now raise an
exception during an interrupt by calling pendsv_nlr_jump. The exception
will be raised when all interrupts are finished. This is used to trap
ctrl-C from the USB VCP to break out of running Python code.
Damien George
mux
ian-v