All board config macros now begin with MICROPY_HW_.
Renamed PYBv10 to PYBV10, since macros should be all uppercase.
Made SDCARD_DETECT configurable in mpconfigport.h, so that the SD
detect pin can be easily configured.
Can now choose at boot up whether the USB device is CDC+MSC or CDC+HID.
Choice is made by an option in boot.py, with default being CDC+MSC.
HID+MSC is not currently supported, but should be easy to implement.
Boot up now has ability to change the reset mode: hold down USR switch
while booting and LEDs will count from 1 to 7 to indicate the boot mode.
Release USR when correct mode is selected. Current modes are 1 (normal
boot), 2 (safe mode), 3 (reset FS mode).
New USB HAL is quite a bit improved over previous one. Now has better
callbacks and flow control.
REPL over USB CDC now works as before, except for soft-reset (since USB
driver uses malloc...).
Each built-in exception is now a type, with base type BaseException.
C exceptions are created by passing a pointer to the exception type to
make an instance of. When raising an exception from the VM, an
instance is created automatically if an exception type is raised (as
opposed to an exception instance).
Exception matching (RT_BINARY_OP_EXCEPTION_MATCH) is now proper.
Handling of parse error changed to match new exceptions.
mp_const_type renamed to mp_type_type for consistency.
Using PendSV interrupt at lowest priority, code can now raise an
exception during an interrupt by calling pendsv_nlr_jump. The exception
will be raised when all interrupts are finished. This is used to trap
ctrl-C from the USB VCP to break out of running Python code.
Damien George
mux
ian-v