You can not select more than 25 topics
Topics must start with a letter or number, can include dashes ('-') and can be up to 35 characters long.
60 lines
2.5 KiB
60 lines
2.5 KiB
Safe mode and factory reset
|
|
===========================
|
|
|
|
If something goes wrong with your pyboard, don't panic! It is almost
|
|
impossible for you to break the pyboard by programming the wrong thing.
|
|
|
|
The first thing to try is to enter safe mode: this temporarily skips
|
|
execution of ``boot.py`` and ``main.py`` and gives default USB settings.
|
|
|
|
If you have problems with the filesystem you can do a factory reset,
|
|
which restores the filesystem to its original state.
|
|
|
|
Safe mode
|
|
---------
|
|
|
|
To enter safe mode, do the following steps:
|
|
|
|
1. Connect the pyboard to USB so it powers up.
|
|
2. Hold down the USR switch.
|
|
3. While still holding down USR, press and release the RST switch.
|
|
4. The LEDs will then cycle green to orange to green+orange and back again.
|
|
5. Keep holding down USR until *only the orange LED is lit*, and then let
|
|
go of the USR switch.
|
|
6. The orange LED should flash quickly 4 times, and then turn off.
|
|
7. You are now in safe mode.
|
|
|
|
In safe mode, the ``boot.py`` and ``main.py`` files are not executed, and so
|
|
the pyboard boots up with default settings. This means you now have access
|
|
to the filesystem (the USB drive should appear), and you can edit ``boot.py``
|
|
and ``main.py`` to fix any problems.
|
|
|
|
Entering safe mode is temporary, and does not make any changes to the
|
|
files on the pyboard.
|
|
|
|
Factory reset the filesystem
|
|
----------------------------
|
|
|
|
If you pyboard's filesystem gets corrupted (for example, you forgot to
|
|
eject/unmount it), or you have some code in ``boot.py`` or ``main.py`` which
|
|
you can't escape from, then you can reset the filesystem.
|
|
|
|
Resetting the filesystem deletes all files on the internal pyboard storage
|
|
(not the SD card), and restores the files ``boot.py``, ``main.py``, ``README.txt``
|
|
and ``pybcdc.inf`` back to their original state.
|
|
|
|
To do a factory reset of the filesystem you follow a similar procedure as
|
|
you did to enter safe mode, but release USR on green+orange:
|
|
|
|
1. Connect the pyboard to USB so it powers up.
|
|
2. Hold down the USR switch.
|
|
3. While still holding down USR, press and release the RST switch.
|
|
4. The LEDs will then cycle green to orange to green+orange and back again.
|
|
5. Keep holding down USR until *both the green and orange LEDs are lit*, and
|
|
then let go of the USR switch.
|
|
6. The green and orange LEDs should flash quickly 4 times.
|
|
7. The red LED will turn on (so red, green and orange are now on).
|
|
8. The pyboard is now resetting the filesystem (this takes a few seconds).
|
|
9. The LEDs all turn off.
|
|
10. You now have a reset filesystem, and are in safe mode.
|
|
11. Press and release the RST switch to boot normally.
|
|
|