This prefix isn't actually used and only adds noise, so remove it.
It may have been useful on Linux that makes a distinction between
/dev/ttyACM* and /dev/ttyUSB* but it isn't now. Also, it's unlikely that
the same vid/pid pair will be shared between an acm and usb driver
anyway.
This makes it possible to flash a board even when there are multiple
different kinds of boards attached, e.g. an Arduino Uno and a Circuit
Playground Express. You can find the VID/PID pair in several ways:
1. By running `lsusb` before and after attaching the board and looking
at the new USB device.
2. By grepping for `usb_PID` and `usb_VID` in the TinyGo source code.
3. By checking the Arduino IDE boards.txt from the vendor.
Note that one board may have multiple VID/PID pairs:
* The bootloader and main program may have a different PID, so far
I've seen that the main program generally has the bootloader PID
with 0x8000 added.
* The software running on the board may have an erroneous PID, for
example from a different board. I've seen this happen a few times.
* A single board may have had some revisions which changed the PID.
This is particularly true for the Arduino Uno.
As a fallback, if the given VID/PID pair isn't found, the whole set of
serial ports will be used.
There are many boards which I haven't included yet simply because I
couldn't test them.
Instead of specifying explicit commands, most of these commands have
been replaced by more specific properties.
This is work that will be necessary for an eventual -programmer flag to
the compiler, with which it is possible to select which programmer to
use to flash or debug a chip. That's not very useful for boards that
already include a programmer or bootloader for that purpose, but is very
useful for novel boards or single-purpose boards that are not already
included in TinyGo.
Kenneth Bell
Ayke van Laethem
sago35
Ron Evans